Specific AGV to Specific AGV pathway

Question

question

gilbert K asked Mar 22, '24 Jason Lightfoot commented Mar 25, '24

Specific AGV to Specific AGV pathway

How to control specific agv only travel on the specific path?

For instance, in my map, I would like to move

1. Control point 22 --> Control point 79 with AGV 11

2. Control point 26 --> Control point 81 with AGV 17

Can anyone please help me to solve this issue?? Thank you!!

AGV simulation practice 1.fsm

Software Version:

FlexSim 24.1.0

agv agvpath agvcontrol

flexsim-question.png (303.9 KiB)

agv-simulation-practice-1.fsm (238.6 KiB)

· 2

Felix Möhlmann commented · Mar 22 at 10:32 AM

Your model wasn't uploaded successfully and there isn't enough context about the situation in your model in the post alone to give good advice. Could you try to upload it again?

0 ·

gilbert K Felix Möhlmann commented · Mar 23 at 01:58 AM

I uploaded model again. If you can't open the model please let me know!! thank you.

0 ·

Answer 1 · 2024-03-23T06:58:03Z

Joerg Vogel answered Mar 23, '24 Jason Lightfoot commented Mar 25, '24

AGV module: A navigator is looking for shortest route to a destination. Once you know that control points must be part of a route you can divert a vehicle over them one by one. If a control point is acquired by a navigator and this is a destination, you can add a next destination of your route to be evaluated. In this chain of destinations you can define a whole path of a travel. It is important that each new part of this chain allows only exactly one path to a next destination.

· 1

Jason Lightfoot ♦ commented · Mar 25 at 12:51 PM

You might also look at this answer relating to the detection of building the travel path.

0 ·

question