lot-flow-1-plane-customstate-2-itemtype2.fsm
Hi.
I am using 7.5.2 and am trying to customize the states.
Can anyone help me try to figure out as to why my state chart shows WaitForTech_REPAIR even when I put it as a statement in the code by adding // at the beginning task? I am trying to substitute Waiting for Operator to WaitForTech_REPAIR and breakdown to On_REPAIR (once the technician has begun it's task).
Thank you!
lot-flow-1-plane-customstate-2-itemtype2.fsm
Thank you!
It seems like this would be better as its own post. Do you mind posting this as a separate question?
Acknowledged on this @Sam Stubbs . Thank you for your suggestion.
I just added a "//" to the code and it seems to have removed the state from the chart for me.. Did you check to make sure the Code had been applied?
On a side note. You may want to add an On Model Reset trigger that resets all of the Custom States on Plane17 back to a default Idle state or something. I think your model still has the states saved from last time the model runs, which is where the WaitForTech_Repair was possibly coming from.
I've reattached your model with a basic example of this:
4 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
