question

Lorenz N avatar image
0 Likes"
Lorenz N asked Lorenz N commented

Error while going through FlexSim Healthcare Tutorial Task 1.2 Step 5

I am currently going through the FlexSim Healthcare Tutorial. I have gone through all the steps for Task 1.2. After completing step 4 where you add a Two Staff Meet(Consult) block and an Escort to Exit block, I keep running into the same error. I believe I have done everything correctly up to that point. It seems to have a problem releasing the MD but the RN is fine?

Attached is the model as well.
Tutorial New HC 1.fsm

FlexSim 20.0.6
healthcaretutorialflexsim 20.0.6tutorial model not working
error-image.png (20.2 KiB)
tutorial-new-hc-1.fsm (299.0 KiB)
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

·
tannerp avatar image
0 Likes"
tannerp answered Lorenz N commented

@Lorenz N,

The activity "Release Exam Table" isn't quite in the container, so the token can't enter the activity properly. It's just the way that the activity was placed in the Process Flow container, but all your code and everything else is correct.

Moving the activities inside the container seems to fix the issue.

tutorial-new-hc-1_1.fsm


· 1
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Lorenz N avatar image Lorenz N commented ·

Thank you so much. Did not even notice that. Can't believe something as small as that could have messed up my model.

0 Likes 0 ·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.