question

Lenny C avatar image
0 Likes"
Lenny C asked Ben Wilson commented

Flexsim Wall Identification and Duplication

Hi,

Attached is a screenshot of a portion of my model and A* Navigator Properties. As seen from the screenshot, my model has a lot of walls, but it seems like the A*Navigator only show 5 walls. May I know how flexsim identify/separate walls?

Also, it seems like after adding all the 5 walls reflected into the A*Navigator, all the walls in my model gets duplicated. Would like to also check how we can correct/prevent this duplication.


Thank you!

FlexSim 20.0.10
flexsim 20.0.10model buildingduplicatewall
flexsim-walls.png (361.2 KiB)
· 1
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Ben Wilson avatar image Ben Wilson ♦♦ commented ·

Hi @Lenny C, was david.chan's answer helpful? If so, please click the red "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.

If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always unaccept and comment back to reopen your question.

0 Likes 0 ·

1 Answer

·
David Chan avatar image
1 Like"
David Chan answered David Chan commented

@Lenny C

all the walls that are connected are considered as the same wall. If you have copy and paste, the wall is actually at the same location as the parents. You can see them when you move the pillars.

David

· 2
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Lenny C avatar image Lenny C commented ·

Hi @david.chan, i actually didnt use copy paste when building the walls in my model. However, after adding all the walls into my A*Navigation, the walls get duplicated. I found this out after i tried to shift the pillars around after adding in A*Navigation. May i know what is causing the duplication?

0 Likes 0 ·
David Chan avatar image David Chan Lenny C commented ·

Your issue were not able duplicate, so I am not sure what has happened.

If I create the wall from the library, one node of wall is in my AStar list. If I copy and past, then I could see two nodes of walls in my list.

It could be unknowingly, you have copy and paste the wall.

Regards

David

0 Likes 0 ·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.