Problem in robot loading under agv

Question

question

Donia M asked Jun 22, '22 Donia M commented Jun 22, '22

Problem in robot loading under agv

Hello,

I have a problem when loading an item from Queue aun unload it under the agv.

As you can see from the example, the end of the robot is immersed in the "basicFR2" when picking and moving the item from the container (Queue 1) to the agv.

The second problem consists in the unloading of the item.We can not see the item under the agv, I think that is placed in the agv.

Is there any possibility to forced the robot to load the item from the container and unload it under the agv without immersing in the BasicFR2 and then put this item under the agv (and see it clearly).

You fin in attached file the example.

Than you in advance

test robot.fsm

Software Version:

FlexSim 22.1.2

agv robot path

test-robot.fsm (1.6 MiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2022-06-22T11:34:52Z

Felix Möhlmann answered Jun 22, '22 Donia M commented Jun 22, '22

For the robot arm I would suggest to either use the Motion Paths motion mode which gives you complete control over the path the arm travels along.

Or get the coordinates of the item and agv in the process flow and use those to define a rough path for the arm to travel in sequence (demonstrated in attached model).

Because you deleted the clamp part of the robot, the item vanishes when picked up by the robot. To circumvent this, you can move it into the last part of the arm directly (see model).

Then use the 'On Entry' trigger of the agv to adjust the location of the item after it is moved into it (also see model).

test-robot_1.fsm

test-robot-1.fsm (1.2 MiB)

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Donia M commented · Jun 22, 2022 at 11:42 AM

Thank you a lot !

0 ·

question