question

Tomi Kosunen avatar image
0 Likes"
Tomi Kosunen asked Paula LG answered

ProcessFlow problem, starts at 1 sec

Hi

I made some small modifications to the model and it stopped working correctly. After short research I located the problem into ProcessFlow. Schedule sources that are supposed to start at 0, start at 1 (sec). After Reset the EventListViewer shows new new event at 1: Process Flow Tick Event and all the Schedule sources are found under /Tools/ProcessFlow/ProcessFlow>stats/tickList

Any idea what has happened? I was able to re-create the modifications to the earier model version, so the modeling continues normally.


1738741135441.png


FlexSim 24.0.8
processflow
1738741135441.png (63.3 KiB)
· 3
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Lars Jacobsen avatar image Lars Jacobsen commented ·
Can you make a demo model with the problem?
0 Likes 0 ·
Tomi Kosunen avatar image Tomi Kosunen Lars Jacobsen commented ·

I found node "useTicker" under ProcessFlow/variables. It was set to 1. If I manually change it to 0, the model seems to work fine again

0 Likes 0 ·
Tomi Kosunen avatar image Tomi Kosunen commented ·

@Lars Jacobsen Pls find attached a sample model. I removed everything else but two PrcessFlow sources.

ProcessFlowProblem.fsm


0 Likes 0 ·

1 Answer

Paula LG avatar image
0 Likes"
Paula LG answered

Hi Tomi,

Do you have this box checked on the process flow properties panel? (See image below)

1738746768970.png

If you do, you should uncheck it.


1738746768970.png (15.8 KiB)
· 1
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Tomi Kosunen avatar image Tomi Kosunen commented ·
There it is! Thanks. I have checked that by mistake. Thanks
0 Likes 0 ·