question

Sean Goh avatar image
0 Likes"
Sean Goh asked Ben Wilson edited

System Console Pop out problem when using Dashboard ?

1) Last few days, I keep getting System Console window pop out (refer to attached JPG files) when I open any existing and new models with Dashboard display. I was using Flexsim Version 17.0.1 then. It seems to happen after I try saving some Dashboards to HTML files.

system-console-error-could-not-write-html-file.jpg(253.1 kB)

system-console-error.jpg(226.5 kB)

2.After I upgrade to Flexsim Version 17.0.3, it still has the System console pop out (blank window) whenever I open any model files with Dashboard. If I close the System console and run the model, some of the Dashboard display cannot be seen. I need to reopen the System console, close it again and then the dashboard display can be seen.

3.Now whenever I add Dashboard when creating any new model, the System console always pop out with message “exception: could not write html file”.

dashboard-system-console-error.jpg

You can refer to attached sample “tryout.fsm” model which I created to experiment with this issue.

Please help advise on this problem and how to fix this ? Thanks!

@[email protected]

dashboard displaysystem consoleexport all dashboards to html
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

·
Phil BoBo avatar image
1 Like"
Phil BoBo answered Ben Wilson edited

The "could not write to html file" exception is usually related to permissions on the C:\ProgramData\Flexsim\FlexSim17.0\help directory. See exception: Could not write html file (User Manual) - FlexSim Community Forum

· 1
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Sean Goh avatar image Sean Goh commented ·

Thank you very much for the advice. Have enabled the control permissions on the C:\ProgramData\Flexsim\FlexSim17.0\help directory and it is working fine now without the exception message.

0 Likes 0 ·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.