hvcphase4.fsmTrying to have patients sent to nurse with lowest workload in Phase1 Area, but workload logic in global tables is not followed. Nurse can have up to 2 patients each regardless of acuity. If Phase1_Nurse1 has one patient then I would want the next patient to go the Phase 1_Nurse 2 and so on. Trying to use the logic in from model posted by @Matthew Gillespie on how to assign workload by zone. Slight variation in my model is that a separate group of nurses are bringing the patients
You can take this one off of your queue. I was able to finally figure it out after some study. Updated model attached hvc-phase6.fsm I was missing a few steps including the triggers to decrement the patient count as patients left, etc. Also the a global reset trigger. Take this one off of your queue @Matthew Gillespie
6 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
