question

Jay avatar image
0 Likes"
Jay asked Isaac Litster edited

load work and unload work on the way

From the attached model, the point is that Queue3 car will run to get to the second round. In this model, I want to work just one round and get to the ParkPoint.

ex.fsm

FlexSim 18.1.2
load work and unload work on the way
ex.fsm (97.9 KiB)
· 3
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Isaac Litster avatar image Isaac Litster commented ·

I'm not sure if I understand correctly. Do you want the AGV to stop at the ParkPoint after it goes one round?

0 Likes 0 ·
Isaac Litster avatar image Isaac Litster Isaac Litster commented ·

I edited the model. Let me know if this is what you were thinking.park-point.fsm

0 Likes 0 ·
park-point.fsm (97.9 KiB)
Jay avatar image Jay Isaac Litster commented ·

I want TaskExecuter1 receive work at Queue3 in first round, in model notice TaskExecuter1 receive work in second round.

0 Likes 0 ·

1 Answer

Isaac Litster avatar image
0 Likes"
Isaac Litster answered Isaac Litster edited

In the Process Flow Properties under Process Flow Variables, the UnloadToEmpty was set to 1. If it is set to 1, the AGV will continue to unload because it is still carrying a load. If you set it to 0, this should fix your problem. I uploaded the model below. Hope this helps!

unloadtoempty.fsm


unload-to-empty.png (111.1 KiB)
unloadtoempty.fsm (99.0 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.