question

Sara Bonansea avatar image
0 Likes"
Sara Bonansea asked Matthew Gillespie commented

Statistics updating of MFC after warmup

Hi everyone!

I have started using mass flow conveyors in FlexSim 22.0.1 and I am struggling with the following problem. The steps to reproduce it are the following:

1) Drag a Source, a Mass Flow Conveyor and a Sink into the 3D model;

2) Connect them using an "A-connection";

3) Set a warmup time (after 1 hour of simulation for example);

The statistics in the mass flow conveyor are correctly cleaned when the warmup fires, but then they no longer update.

Is it a bug or an issue?

WarmupAndStatisticsMFC.fsm

FlexSim 22.0.1
mfc
warmupandstatisticsmfc.fsm (36.7 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Ryan Clark avatar image
0 Likes"
Ryan Clark answered Matthew Gillespie commented
Hi @Sara Bonansea,

This does appear to be a bug. I added a case to the dev list, so it should be addressed at some point in the near future.

· 2
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Sara Bonansea avatar image Sara Bonansea commented ·

Hi @Ryan Clark , thank you so much for your response and for adding the case to the developer list!

1 Like 1 ·
Matthew Gillespie avatar image Matthew Gillespie ♦♦ Sara Bonansea commented ·
This bug has been fixed for 22.0.10 which will be out next week.
0 Likes 0 ·