question

Zdenek K2 avatar image
0 Likes"
Zdenek K2 asked Zdenek K2 answered

Sending TaskExecutor to Slot location in Travel command

Hello,

I´ve been having an issue to send loaded task executor back to assigned slot via travel command in my attached model. When Iam picking from rack I am sending TE to item location(yellow Travel brick), however it is not possible when trying to bring it back to rack after processing the item. Is there any simple way how to make TE travel back to original slot and unload the Tote there?

Thank you so much!

Z.

FlexERR.fsm


FlexSim 21.1.5
warehousetravelslot
flexerr.fsm (52.2 KiB)
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jason Lightfoot avatar image
0 Likes"
Jason Lightfoot answered

The slot isn't an object so you can't travel to it.

Normally you would just unload to the the rack having re-assigned its original slot - which will work if you set the executer to use the navigator for offset travel.

Model attached.

flexerr_jl.fsm


flexerr-jl.fsm (53.7 KiB)
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Zdenek K2 avatar image
0 Likes"
Zdenek K2 answered

Thanks both of you for solution, works exceptionally.

Z.

5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Joerg Vogel avatar image
0 Likes"
Joerg Vogel answered

This model reassign the slot to item right after loading from rack. Later the agv travels back to rack object and relatively to slot location. Then the item gets unloaded.

flexerr-JV.fsm


flexerr-jv.fsm (53.6 KiB)
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.