Set Object State by Custom code but State not change

Question

question

Anutt K asked Jan 10, '23 Anutt K commented Jan 11, '23

Set Object State by Custom code but State not change

Hello. In this case I want to use 2 Operators start travel together but once of Operator will arrive first at the destination.

In case of need to use Spilt and Joint in 2D logic from this picture, Operator2 will arrive the destination before Operator1. So Operator2 will be Idel state.

Then I use custom code for try to Set State of Operator2, It should be Waiting state.

How can I set object state in this case at use Split and Joint.

I has attached model here. Thank You.

Test Set State Object in Split.fsm

Software Version:

FlexSim 22.2.2

custom code split customecode joint set object state

1673315831474.png (127.7 KiB)

test-set-state-object-in-split.fsm (50.5 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2023-01-10T08:32:26Z

Felix Möhlmann answered Jan 10, '23 Anutt K commented Jan 11, '23

When overwriting states of an object, timing is important. In this case, when the travel operation ends, the Process Flow token moves to the next activity and executes it before the state change back to "idle" happens. Because the custom change happens first, it is then immediately overwritten again by the pending change back to "idle".

By placing a 0s delay after the travel activity, you can make sure that the default state change has happened before the custom one is executed.

test-set-state-object-in-split_1.fsm

1673339525623.png (11.1 KiB)

test-set-state-object-in-split-1.fsm (50.9 KiB)

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Anutt K commented · Jan 11, 2023 at 01:36 AM

Ok. I get it from your explain. Thank You so much.

0 ·

question