question

Ryusuke T avatar image
0 Likes"
Ryusuke T asked Ryusuke T answered

Questions about drawing

Hi,

I am verifying using agent system. In the agent system, does the detection timing change depending on the simulation execution speed? (Does the result differ depending on the drawing process?)


Also, are there any effects when using the optimizer? (Since the optimizer does not perform drawing processing, we are concerned that it may affect the results.)

FlexSim 23.0.11
agent systemdrawing
· 5
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jason Lightfoot avatar image Jason Lightfoot ♦♦ commented ·
It should not - do you have a test model where your suspect this is not the case?
0 Likes 0 ·
Ryusuke T avatar image Ryusuke T Jason Lightfoot ♦♦ commented ·

@Jason Lightfoot ,

The model that was sent separately in private will be the applicable model.

0 Likes 0 ·
Ryusuke T avatar image Ryusuke T Ryusuke T commented ·

My method of verification is to place On Enter Proximity and see if there is a difference in the number of detections in terms of execution speed.

The number of detections actually varies depending on the simulation execution speed.image1.png

0 Likes 0 ·
image1.png (14.9 KiB)
Show more comments

1 Answer

Ryusuke T avatar image
1 Like"
Ryusuke T answered

The cause has been found.

When I checked the tree information of the relevant AGV, OnPreDraw was stored. When I deleted this, the detection timing became constant.

thank you.

5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.