question

Thomas avatar image
0 Likes"
Thomas asked Thomas commented

State of a zone

Hello,

I currently have 10 zones in my process flow and currently want to extract data from them. On the one hand I look at the average lead time for each zone and on the other hand I would also like to look at the status of different zones in a state gantt, but this appears not to be possible. However, I would like to know when it becomes active and no longer active so that I can see where problems may occur. Is this possible?


Thank you in advance!

FlexSim 23.2.1
processs flowzonestate
· 2
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Joerg Vogel avatar image Joerg Vogel commented ·
@Thomas, Can you try to put your zones into a group? You can evaluate events on a group.
0 Likes 0 ·
Thomas avatar image Thomas Joerg Vogel commented ·

Thanks for the alternative!

I have tried it but it remains empty. I suspect because there is no status associated with a zone?

1713508762873.png

Felix's option is what I was looking for, so thank you both!

0 Likes 0 ·
1713508762873.png (5.7 KiB)

1 Answer

Felix Möhlmann avatar image
0 Likes"
Felix Möhlmann answered Thomas commented

Wouldn't the "status" of the zone just be the content and a content vs. time graph would thus show you the same information as a gantt chart?

· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Thomas avatar image Thomas commented ·
Thanks for helping, I was to many focused on the state.
0 Likes 0 ·