question

Shinya O avatar image
0 Likes"
Shinya O asked Jeanette F answered

Right Angles Only behavior is different between 2023 and 2024

Hi,

The attached model is a model created in 2023 and then resaved in 2024. Are the changes summarized in the table below intentional? Is there any way to make it behave like 2023?

Thanks in advance.


 2023.0.11 2024.0.4
rotation angle is a multiples of 90
 Yes No
Turn sequence 1. Delay for half the time set in Turn delay
2. Turn
3. Delay for half the time set in Turn delay		 1. Turn
2. Delay by the time set in Turn delay
Task executor output from a fast-forward one-day simulation run
 406 425


RightAnglesOnly_23.0.11.fsm

RightAnglesOnly_24.0.4.fsm

FlexSim 24.0.4
astarright angles only
rightanglesonly-23011.fsm (29.2 KiB)
rightanglesonly-2404.fsm (31.3 KiB)
· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Shinya O avatar image Shinya O commented ·

We also found that the rotation angle was not repeatable in 24.0.4: in this model, TaskExecutor1 rotates close to 180 degrees immediately after simulation start, but the rotation angle changes slightly from run to run.

Also, the faster the execution speed, the more the rotation angle tends to deviate from 180 degrees.

0 Likes 0 ·

1 Answer

Jeanette F avatar image
0 Likes"
Jeanette F answered

Hello @Shinya O

In version 2023 update 2, there was a change implemented to Add "support for acceleration and deceleration for A* travelers". Please read the release notes for more information.

This has been submitted to the development team for further investigation.

5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.