question

hikel avatar image
0 Likes"
hikel asked hikel commented

Change loading animation

I have a forklift when it start loading same part the lifter goes down. here is the model picking removed part not available.fsm

load-before.png

this is where it start loading first same part

loading.png

This is where lifter goes down

loading-going-down.png

This is where lifter goes up to load same item. is there any way to keep the lifter up when it is same part to be picked. I did allow fork to move while traveling but didn't work. @Felix Möhlmann Do you have any suggestion or solution to this problem?

loading-second.png


FlexSim 23.2.2
animationloadtaskexecutors
load-before.png (195.3 KiB)
loading.png (256.1 KiB)
loading-going-down.png (200.2 KiB)
loading-second.png (249.8 KiB)
picking-removed-part-not-available.fsm (94.2 KiB)
picking-removed-part-not-available.fsm (94.2 KiB)
· 2
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Sebastián Cañas avatar image Sebastián Cañas commented ·
@hikel , you could find something useful from this post
0 Likes 0 ·
hikel avatar image hikel Sebastián Cañas commented ·
Thank you @Sebastián Cañas for the post
0 Likes 0 ·

1 Answer

Felix Möhlmann avatar image
0 Likes"
Felix Möhlmann answered hikel commented

This happens because inbetween each load task the transporter gets a task to travel to the rack again. If you consolidate the "pickArray" so that each pallet only appears once (with the summed up quantity) the travel task only happens inbetween different pallets.

picking-removed-part-not-available_1.fsm

Or you just remove the "Travel to rack" activity. Since the transporters are not using a network, it is not really needed anyway.


picking-removed-part-not-available-1.fsm (94.5 KiB)
· 5
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

hikel avatar image hikel commented ·
@Felix Möhlmann Thank you both of them worked!
0 Likes 0 ·
hikel avatar image hikel hikel commented ·
@Felix Möhlmann just a follow up. i am doing delay for Truck Type for example T1 when picking same part just delay whole number of same part same time (it is working fine) just for T2 truck Type (in Active Table) same part for example when pick part A Qty 5 delay each part (it is working) only problem is lifter keep going down again. Is there any way to solve this problem?
0 Likes 0 ·
Felix Möhlmann avatar image Felix Möhlmann hikel commented ·
If I understand you correctly, you just want loading parts to take some time. If so, just set a load time on the transporter. It'll keep the fork at the right height during that time.
0 Likes 0 ·
Show more comments