Time Table if Task is on hand.

Question

question

Anutt K asked Aug 8, '23 Anutt K commented Aug 9, '23

Time Table if Task is on hand.

Hello. In this case I has assign On Break time to Operator at 8:00:10 to 8:00:25 this duration is 15 Sec.

So, In case of Operator has Task on hand it will On Break when his task at on hand are finish. In this picture the time is 8:00:13 but Operator not Break.

He will finish task at 8:00:15 and Break then.

So, Duration of Break are 15 Sec. The Operator will Break at 8:00:15 to 8:00:30. I use down function in Time Table and assign Priority of Down Function 100 and Priority of Process 101.

So, If I want to assign On Breake time are in the same eventhrough Operator will late from break time because task on hand (Break at 8:00:15 and Resume at 8:00:25 on the same). How can I setting this.

I has attached model here. Thank You.

Time Table but the Task on hand.fsm

Software Version:

FlexSim 23.1.2

time table down behavior

1691507213554.png (184.4 KiB)

1691507435889.png (191.8 KiB)

1691507536083.png (197.0 KiB)

1691507808457.png (91.4 KiB)

time-table-but-the-task-on-hand.fsm (52.9 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2023-08-08T16:45:01Z

Julie Weller answered Aug 8, '23 Anutt K commented Aug 9, '23

Hi @Anutt K! I'm a little confused at what you're asking but if you change the down state to be 35 - on break:

The model seems to work like how you'd expect:

Is that what you're looking for?

1691512956898.png (37.0 KiB)

transport.gif (1.1 MiB)

· 8

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Anutt K commented · Aug 08, 2023 at 05:16 PM

In your picture Start of Down time is 8:00:05 to 8:00:25 that duration is 20 Second.

But Operator will Down at 8:00:19 to 8:00:39 because duration of Start time to End time is 20 Second.

So, If I want to set, when Operator Down at 8:00:19 but I want to Operator Resume at 8:00:25. How can I set it.

0 ·

Julie Weller Anutt K commented · Aug 08, 2023 at 05:26 PM

You could try changing the preemption on the processor:

That way it stops the break when the processor begins again. Would that work for you?

0 ·

1691515556062.png (44.7 KiB)

Anutt K Julie Weller commented · Aug 08, 2023 at 05:34 PM

2023-08-09 00-32-02.gif

I has changed all Preemtion at Processor at all function but it not work.

0 ·

2023-08-09-00-32-02.gif (2.3 MiB)

2023-08-09-00-32-02.mp4 (3.5 MiB)

Show more comments

question