Hey, I have a model that is largely controlled by various process flows. Now I wanted to run an experiment with different scenarios in the experimenter, unfortunately some repetitions break off and I don't know why. If I then simulate them interactively in the 3D model, they work. Sometimes the the experiments works better and sometimes its worse. Do you have an idea why this happened? I have attached the model (some terms are in German, I hope this is not a problem)
Model: Model_1.fsm
At some point when running your model I got an error message about an "invalid destroy operation" followed by a LINK PARITY ERROR.
I have a suspicion that this might be caused by you creating and releasing tokens in code a lot. When releasing tokens like that you have to be very careful about timing. Which is why I would recommend you try to rebuild your Process Flow but use the default "Create Tokens" and "Decide" activities instead.
It might take some time, but in my experience it will be quicker than trying to track down which part of the current Process Flow causes the issues.
17 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
