Hi, Sometimes while writing in code editor and then using "goto definition" to edit a existing function, when I come back to the primary function, my unsaved changes automatically get undone, and the primary function gets back to it's last saved state. This happens randomly sometimes and is hard to recreate. Did any else face such issues ?
@Aditya Prakash I'm not sure why that's happening, but you can also try opening "Command Help" by right-clicking in the code editor or going through the Help tab. That way you can look up definitions on the side bar while still accessing the Code Editor.
If you have the User Commands GUI open then you need to apply that to make the changes. If it's not open, then the code changes will be applied directly from the code editor window - so the behaviour can be different, and might seem random if you haven't noticed what GUIs are open. This is similar to editing triggers with the objects parameters GUI open where you need to press Apply from the GUI, but if the GUI is not open, the code editor applies the code directly.
5 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
