Hi,
like you can see in the attached Picture I´ve add a decision Point to a conveyor. After this I clicked and dragged the DP to another Point (length) on the conveyor. Now it lost the Connection and I can´t figure out how to connect it back? This also happens with stations.
What is the easiest way to connect it back?
This is a strange little hiccup that seems to occasionally crop up. Usually it happens when you're pressing a key, and then switch to another program, and FlexSim still thinks you're holding the key down when you return, which causes this hiccup. I believe they've tried patching it where they could catch it before, but apparently it still seems to show up on occasion. (Actually if you remember anything that you did that lead up to this little glitch, let us know and I can pass it on to the developers. If we can repeat it, it becomes much simpler to fix.)
Anyway, for now you should be able to "reset" FlexSim by going into another open application and then back into FlexSim. If that doesn't work, just try closing the program and reopening it.
@Sam Stubbs thanks for the fast Reply, sadly I can´t reproduce it. If so I would have attached the model. It happened only in one model yesterday. After closing and reopening the model everything works fine. Thanks
11 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
