Good afternoon,
I was reviewing the section on collecting data and dataCollector and was wondering if there is a way to start collecting data from a time slot different than zero. I mean that I want to start collecting statistical data after a few seconds have passed (30 or 40 depending on the case) to eliminate the emptiness in the processors (typical to the start of the day)
In the Run Time settings you can define a warmup time. Once that time is reached all statistical data in the model will be reset, eliminating data from the previous time from dashboards.
(Processor shows 100% utilization shortly after the reset, because it is currently active)
14 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
