question

Jungeun W avatar image
0 Likes"
Jungeun W asked Jeanette F commented

building mass flow conveyor

Hi!

I'm trying to self-studying about building models of mass flow conveyor!

but as i trying to set model in spiral way, the side skirt is floating on the conveyor..!

what is the way to handle the position of side skirt of the conveyor??

thx so much for help!

1672726545844.png

FlexSim 21.1.5
massflowconveyorsideskirt
1672726545844.png (225.7 KiB)
· 2
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Sri_vikas K avatar image
0 Likes"
Sri_vikas K answered Best Answer

Hi @Jungeun W

If you are designing a Spiral Conveyor:

1. Give start angle 180 deg and sweep angle 1080 deg.

2. Then Give End(Z coordinate) a greater number.spiralconproperties.jpg

Refer to the model attached below.

SpiralConveyorModel_SVK.fsm


spiralconproperties.jpg (29.4 KiB)
spiralconveyormodel-svk.fsm (34.9 KiB)
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.