question

Ryusuke T avatar image
0 Likes"
Ryusuke T asked Jason Lightfoot commented

Broken process flow

Hi,

Please check the attached file.

Broken process flow.fsm

Even if the simulation is executed and the simulation is reset after unloading, the token remains in the unload.

If you close the process flow in this state, an error message will be displayed.

Furthermore, when I try to access the process flow from the toolbar, I get an error message and the process flow is blank.

1689750263052.png


The cause seems to occur when the item is set to current when unloading. The version we are using is 2023.0.9, but we have confirmed that it is also reproduced in the latest version 2023.1.3 at the moment.

FlexSim 23.0.9
proces flowbroken
1689750263052.png (10.9 KiB)
broken-process-flow.fsm (36.0 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Jason Lightfoot avatar image
0 Likes"
Jason Lightfoot answered Jason Lightfoot commented

In your unload you're moving the process flow to the processor - since this is a general process flow, current is the process flow, not an item you can move.

1689757840035.png


1689757840035.png (16.3 KiB)
· 4
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Ryusuke T avatar image Ryusuke T commented ·

@Jason Lightfoot ,

The problem is that the process flow is broken and cannot be opened, and the contents of the process flow are all lost.

Since the above problem occurs due to an operation mistake, I would like you to prevent this problem from occurring in future versions.


0 Likes 0 ·
Jason Lightfoot avatar image Jason Lightfoot ♦♦ Ryusuke T commented ·

It's not broken - it's in the Processor:

1689758426837.png

And then when you press reset of course it gets deleted like all processor content.

Users can just go to the previous save and make the correction.

I've long been asking for a safe mode where there are more checks and every error is 'caught' and reported safely - then once fully debugged the mode (and it's performance penalty) could be turned off. If you like this idea then suggest it on the forum or email the dev team.

0 Likes 0 ·
1689758426837.png (3.5 KiB)
Ryusuke T avatar image Ryusuke T Jason Lightfoot ♦♦ commented ·

@Jason Lightfoot ,

it's not. We're talking about the post-reset story.

Thank you.

0 Likes 0 ·
Show more comments