question

Ryusuke T avatar image
0 Likes"
Ryusuke T asked Ryusuke T commented

About cooperation between ExpertFit and FlexSim

Hi,

Since ExpertFit and FlexSim are independent functions, if you want to use the output results of ExpertFit on FlexSim, you need to transfer the output results.

For this reason, there have been requests from customers to allow the output results of ExpertFit to be controlled by Flex scripts.

Is there a way to control it?

FlexSim 23.0.8
expert fit
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Kavika F avatar image
0 Likes"
Kavika F answered Ryusuke T commented

Hey @Ryusuke T, currently there is only one command related to expertfit which is runexpertfit(). If you'd like the results of an ExpertFit run, you'll have to retrieve it manually. There is a way to write to an output file using the "Batch Mode" > "Analysis Options" window to select a location to output the results. You could then have your FlexScript read from that file to retrieve the information after a run.

· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Ryusuke T avatar image Ryusuke T commented ·

@Kavika F ,

Thank you for information.

I understood that the command for expertfit is only runexpertfit ().

0 Likes 0 ·