question

Bryan Quiros avatar image
0 Likes"
Bryan Quiros asked Bryan Quiros commented

Process Flow Not Running After "Push-to-List" Steps

"Operador 1" flow should start right after "Producto" List is pushed but simulation won't start. Operator 1 should start traveling to Queue1, load items and then unload to "Maquina 1 e inspeccion". Could someone help me find why the simulation is not running? File has been attached for verification.

1697845837178.png

WISP Cushion propuesta - Copy.fsm



FlexSim 23.2.0
process flow issue
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Felix Möhlmann avatar image
0 Likes"
Felix Möhlmann answered

The "Operador 1" activity block is started from the "Run Sub Flow" activity. But that one is not connected to anything. I honestly don't know how you even managed to end up with a connector that is not connected to anything.

If the Source was connected to the Run Sub Flow, you would still be missing the "Type1Items" label on it that is used to refer to the items that should be transported. Your intend is probably to assign the items you pull from the list to a label with that name, but you don't pull items anywhere.

No items ever arrive in the Queue1, since the 3d source is not connected to anything, nor are the items moved by any other method. So the Event-Triggered Source in the Process Flow never fires. And if it did, the "Push to List" activity also doesn't link to any list, so you would receive an error as soon as a token enters it.

5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Bryan Quiros avatar image
0 Likes"
Bryan Quiros answered Bryan Quiros commented

Could you please check that again? Im not sure why but the list and connectors in the previous file were gone, now they should be on this file I just atteched.


Please, let me know.


WISP Cushion propuesta - Copy (2).fsm


· 2
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Felix Möhlmann avatar image Felix Möhlmann commented ·

The query in the Pull from List activity mandates that the items need to have a "Type" label with value 1. But the items do not possess a label of that name. If you remove the query, the token will successfully pull an item.

You also shouldn't send the "main" token into the subflow.

capture1.png

0 Likes 0 ·
capture1.png (31.3 KiB)
Bryan Quiros avatar image Bryan Quiros Felix Möhlmann commented ·
Ty, this helped me solved my issue
0 Likes 0 ·