Hi. I played with the conveyors and noticed some strange behaviour. See the model attached conveyorCrossing.fsm. If the conveyor6 and 7 x-location is exactly the same, the item cannot travel across the conveyor3. It will turn and travel to horizon instead. If the conveyor7 x-location is just a little on the right (5.00001) the item will find its destination correctly.
Hi @Tomi Kosunen, was David Seo's answer helpful? If so, please click the "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.
If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always comment back to reopen your question.
It's not bug. It is absolute normal. The conveyor3 conveys the item when the item enter the side edge.
If you connect with conveyor6 and 7 at one point ( at one transfer), the item flow normal as you think.
Thanks @David Seo . I tried to figure out, how to connect/resize/connect the conveyors, with no success. I modified the model a bit. How would you edit the model to make the green items flow up to DP3 and red items to DP2? (if you don't translate the Conveyor6 and 7 in x direction) conveyorCrossing_2.fsm
I'm going to send in another ticket to the developers linking to this post as more evidence that this should be supported.
@Tomi Kosunen This has been fixed in FlexSim 24.0.3 released today.
10 People are following this question.
© 1993- FlexSim Software Products, Inc. All Rights Reserved.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
