question

unai avatar image
0 Likes"
unai asked unai commented

Parameters in the source's arrival sequence

Hello,

I want to know if it is possible to use a parameter to set the value of the quantity in the table of the arrival sequence of the Source1 because I want to use the experimenter to simulate different scenarios with different quantities. The aim of this source is to create the items in at the beginning of the simulation and I would like to use the parameters to create new scenarios with more quantities of the arrival sequence like I have done in the Source2. Here it is attached the example of the model:

Example.fsm

FlexSim 22.1.4
parameters arrival sequence
example.fsm (146.3 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Paula LG avatar image
0 Likes"
Paula LG answered unai commented

Hi Unai,

To do so, you just have to open the arrivals table of the source and then sample the quantity cell from the parameter tab.

1708438765956.png

I hope it helps!


1708438765956.png (36.3 KiB)
· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

unai avatar image unai commented ·
Yes, thank you very much!
0 Likes 0 ·