send to port based on reorder point

Question

question

poopatel asked Feb 26, '24 Jeanette F answered Feb 27, '24

send to port based on reorder point

I want to send parts from PDC1 to QueueSC1, Queue SC2 and PDC4 to Queue SC7. I build a process flow that work based on reorder level and reorder quantity however its the part are not going correctly to QueueSC1, QueueSC2, or QueueSC7. Can someone review this?

scenerio_5_logic.fsm

Software Version:

FlexSim 23.2.0

pull from list subprocessflow reoder point

1708987747717.png (294.5 KiB)

1708987755995.png (16.8 KiB)

scenerio-5-logic.fsm (78.6 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2024-02-27T20:51:10Z

Jeanette F answered Feb 27, '24

Hello @poopatel,

When you release an item from a queue you are setting the send to port logic to run again. Which in this case is sending the item to the list. You will need to move the objects to the processor. You could do it like the following. The sub flow creates a token for each item and runs them one at a time.

scenerio-5-logic_1.fsm

1709067037645.png (85.3 KiB)

scenerio-5-logic-1.fsm (81.8 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

question