question

wooram-kim avatar image
0 Likes"
wooram-kim asked Jeanette F commented

The amounts of Input and Output of FluidProcessor is not same.

Hi,

I modeled two fluid lines (output_fluidprocessor.fsm).

In the models, 15 liters of fluid are generated every minute, and the material is processed for 800 seconds and get terminated.

The only difference of the two lines is a fluid conveyor between ItemToFluid and FluidProcessor. The conveyor does not spill its fluid.

In without-conveyor line, FluidProcessor receives 15 liters and sends 15 liters every minute.

But, in with-conveyor line, FluidProcessor receives 15 liters and sends 15.92 liters every minute. I think the output value has some problem because the output value cannot bigger than input value in the model.

그림1.png

The following figure shows the result of simulation for 20000 seconds. I think with-conveyor line is also supposed to show similar result with without-conveyor line.

그림2.png

Thank you.

FlexSim 24.1.0
fluid conveyorfluid processor
· 4
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Logan Gold avatar image Logan Gold ♦♦ commented ·

Hi @wooram-kim, was Jeanette F's answer helpful? If so, please click the "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.

If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always comment back to reopen your question.

0 Likes 0 ·
wooram-kim avatar image wooram-kim Logan Gold ♦♦ commented ·
I want to know if it is a bug.

If it is a bug, will it be fixed?.

If it will be fixed, can I get a notification when it is patched?


0 Likes 0 ·
Jeanette F avatar image Jeanette F ♦♦ wooram-kim commented ·
Hello @WooRam_KIM,

The development team has been notified of this. The development team will reply to this post with a fix when it becomes available.

0 Likes 0 ·

Hi @wooram-kim, was Jeanette F's answer helpful? If so, please click the "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.

If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always comment back to reopen your question.

0 Likes 0 ·

1 Answer

Jeanette F avatar image
0 Likes"
Jeanette F answered Logan Gold edited

Hello @WooRam_KIM,

The processor2 spends a second too long releasing at the outputrate of .92.

This has been submitted to the development team for further investigation.


5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.