What would be the most likely cause for a "stack overflow detected" message?

Question

question

Tee Hiett asked Jan 30, '17 Jordan Johnson commented Feb 1, '17

What would be the most likely cause for a "stack overflow detected" message?

I get the following system error message only in Replication 31 (of 48) and scenario 1 (of 2). If I run fewer than 31 iterations I do not get the error message.

My computer specifications are:

Thanks,

Tee

Software Version:

FlexSim HC 5.1.0

stack overflow

oelut.png (20.6 KiB)

z0jmq.png (6.0 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2017-01-30T18:23:25Z

Matthew Gillespie answered Jan 30, '17 Jordan Johnson commented Feb 1, '17

Stack overflow is usually caused by too much recursion (i.e. a function calling itself too many times). However, why this is happening in your model is hard to guess without seeing your model. You can post it in a private question if you want someone to look at it.

You can also go the the explore tab of the experimenter, choose replication 31, and then run the model to see what happens in that replication.

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jordan Johnson ♦♦ commented · Feb 01, 2017 at 06:16 PM

This message can also be generated by a message sending loop.

1 ·

question