When using A*, I can't dreate the divider, one-way divider and preferred path in the model.
The starting spot is created but I can't finish the end point.
That error belongs to Divider, One-Way Divider and Preferred Path all the same.
But the Barrier can be done well.
What's problem of them? I don't know why it happens.
Is there another way to create the divider?
Hmm that is strange, using them should just be straightforward. Select the tool then a single left click somewhere in the model floor, will start the point, each single left click should add a new point. And right-click should exit out of the drawing function. This does not work for you? Have you tried quitting and restarting FlexSim?
Today I can do it. Why is it?
If it happen again, quiting and restarting is a solution? Hmm...I remember it sometimes to happen.
Strange. I'll play around with it, but if it happens again let us know. Try to note as many details as you can about the situation (what you did before etc.) to help us try to recreate the issue. It's possible that there's a bug of some kind.
9 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
