question

Manuel F. Silva avatar image
0 Likes"
Manuel F. Silva asked Manuel F. Silva answered

Problem / doubt in FlexSim AGVs tutorial - Task 4.3 - Step 6

After completing "STEP 6 Add Elevator Redirect and Entry Control Points" of the "Tutorial 4 - AGVs - TASK 4.3 - USING ELEVATORS WITH AGVS", I am not being able to make the elevator go up and down. The AGVs just cross the elevator to go to the different floors (and return from there) but without any movement of the elevator.

I attach the model on which I was working so that you can take a look at it: Automatic Guided Vehicles (AGVs) (1).fsm

Can anyone explain what I might be doing wrong. Thanks in advance.

FlexSim 21.0.4
flexsim 21.0.4
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Manuel F. Silva avatar image
0 Likes"
Manuel F. Silva answered

Dear @Seung Yong Seo, thank you very much for your assistance and explanation. In fact, after repositioning the control points, my model started working perfectly.

5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

David Seo avatar image
0 Likes"
David Seo answered

@Manuel F. Silva

You should drag and drop the control point on the path line EXACTLY to show the cross line in center of the control point like attached.

And then you can find the good result.

Your model is good.


5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.