So this is a recurring but intermittent problem that makes no sense to me. I am writing FlexScript code as part of processflow blocks and it just won't become permanent. My steps:
- I make changes to code
- I check it
- I apply it
- I say ok
- I reopen it to verify that the changes are still there (sometimes not but I keep re-entering the changes until they are)
- I'll save the model
- I'll close the model and reopen
- I run the model
Code changes are gone!! The code reverts to previous code
I work in a secure environment and can't share model.
I saw a similar question in the past but it didn't have a definitive solution.
Thanks
Steve
