question

Stephen M2 avatar image
0 Likes"
Stephen M2 asked Stephen M2 commented

FlexScript code changes keeps disappearing

So this is a recurring but intermittent problem that makes no sense to me. I am writing FlexScript code as part of processflow blocks and it just won't become permanent. My steps:

  • I make changes to code
  • I check it
  • I apply it
  • I say ok
  • I reopen it to verify that the changes are still there (sometimes not but I keep re-entering the changes until they are)
  • I'll save the model
  • I'll close the model and reopen
  • I run the model

Code changes are gone!! The code reverts to previous code

I work in a secure environment and can't share model.

I saw a similar question in the past but it didn't have a definitive solution.

Thanks

Steve


flexsim 20.2.3flexscriptunrecognized error
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

·
Phil BoBo avatar image
1 Like"
Phil BoBo answered Stephen M2 commented

Looking through closed cards in our issue tracker, I found a card related to ProcessFlow code not getting properly applied that has been fixed. Try updating to a newer version of FlexSim.

· 1
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Thanks will do

0 Likes 0 ·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.