question

Hello @Aaupadhye ,

For starters you have some assignments being done twice in your model. For instance, in the process flow you assign the station the item will go to and then you direct the flow item at the DP before the station based off of round robin. If you follow your first item created you will see it was assigned Queue 3 but arrived at Queue 2. So do you want process flow to control the assignment or for the DP to use round robin? I set it up to use the DP round robin logic since that is already working

You can have an exit transfer on the box conveyor that pushes the box to a list. Your flow item can then be pulled from this list. I would push the box into a partition on the list that corresponds with the station so when you are pulling an item from the list you pull the correct box for that station.

The other thing you can do is use 3D connections to be able to make references to other needed objects. For instance I connected the box conveyor to your Station but since the output of the exit transfer pushes items to a list for its output it doesn't send them to the station. However I can still use that connection as a reference when sending the items to the list when partitioning. In your process flow assign labels activity you will see where I use the other connections to create the references.

In your process flow I separated the tote creation from the station logic. To initiate a token in the Station logic I have all the stations in a group which is referenced in the event triggered source. So when a tote enters a station a token is created with a reference to the tote and station.

Step through each activity to see how it was configured for this to work.

mwfcbaggersim_JF.fsm