change operator during process when shift change?

Question

question

melissa paredes asked Jun 23, '16 Adrian Haws commented Jul 25, '16

change operator during process when shift change?

I have 1 processor and 2 operators each of them have to work by turns (time table break), the process is to long for 1 operator to finish it. How can I do for the operator to switch during process time

Software Version:

FlexSim 16.0.1

operator breaks shift

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2016-06-23T18:25:06Z

Lucas Antonio Risso answered Jun 23, '16 Adrian Haws commented Jul 25, '16

First of all, both operators must be connected to a same dispatcher.

Secondly, you have to set an "A" connection from the dispatcher to each operator, and also another "A" connection in the opposite direction, from the operator to the dispatcher. The latter will make an unfinished task sequence "return" to the dispatcher in order so that it can be sent to another operator.

I did a demo model to show it, please check if it answers your question. shift-tests.fsm

If it doesn't work, please, share your model.

shift-tests.fsm (37.5 KiB)

· 2

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Felix Sims commented · Jul 25, 2016 at 05:15 PM

Hi,

Is there a way to do this with a custom fixed resource. I kept the shift schedule the same but once the operator stops the processing stops even though there are two operators connected. 901-shift-tests.fsm

0 ·

901-shift-tests.fsm (52.3 KiB)

Adrian Haws Felix Sims commented · Jul 25, 2016 at 11:09 PM

@Felix Sims I didn't seem to see any issue when I ran your model. At 80 model seconds the seventh item is being processed (with the 11 second processing time). Am I misunderstanding the problem?

0 ·

question