Error: A token is leaving without entering zone.

Question

question

Kari Payton asked Sep 23, '16 Kari Payton answered Sep 23, '16

Error: A token is leaving without entering zone.

Hi. I need help figuring out why I am getting the error on my Limit zone. I am trying to use the new split and join feature. It seems to me that the token enters the zone at the very beginning and at the very end exits the zone. I don't see why I am getting this error.

Software Version:

FlexSim 16.2.0

zone split join

zone-error.png (219.5 KiB)

· 1

Jeff Nordgren commented · Sep 23, 2016 at 02:52 PM

@Kari Payton

Kari,

Hard to figure out anything from a picture. Can you send the model?

1 ·

Answer 1 · 2016-09-23T14:52:43Z

Kari Payton answered Sep 23, '16

Just figured it out after posting, but if anybody else run into this error....On my last split, the first connector goes to the right and the second connector goes to the left. When I stepped through, I noticed that the token on the right was entering the zone after the token from the left joined it. The error came because the token that split to the right wasn't the same token that entered the zone in the start of the process flow. So to solve this I made the first connector come out of the left and the second connector on the right, on the last split point.

question