model-1.fsmI have been imported the Turn Table13 from my previous model to this Model 1 and i needed to place this in between conveyors C4 and C5 But the object of Turn Table13 is not visible and also conveyors are not visible in Render Mode.
Imported Objects Invisible
FlexSim 19.1.0
Same way my installed flexsim 2019 is not showing any object on the screen
Hi @Venkatesh Babu H, welcome here at answers site of FlexSim. An Article describes several steps to solve your graphic issue.
Graphics Compatibility - Common Problems and Solutions
After you have tried the solutions and you can’t still see any of your objects, then you are welcome to come back and ask a new question. Point 9 describes well, what the developers need to help you. Regards Jörg.
This is typically an issue of the graphic card. I have this behavior on my notebook. The hardware is outdated. You can update or downgrade the graphic card driver. Please post your hardware type and driver versions.
For the Conveyor Render Mode, click on a conveyor -> System Properties -> General Tab -> Click on Draw Render Mode. (If this is not what you're looking for please let me know.)
As for the Turn Table13 could you upload the other model so that I can see the Turn Table in the original model?
render-modemodel-1.png @Zachary H Hi sir but my question was not that,if i switch into a render mode i can't see conveyors and i have attached a image file file of my issue could you please go through it and thank you turntable.fsm
11 People are following this question.
