How to make transporter to wait until Separator finishes.

Question

question

JoseVM asked Mar 12, '20 JoseVM commented Mar 12, '20

How to make transporter to wait until Separator finishes.

Hello,

I am quite new in FlexSim and I have some problems regarding to batches. I would like to transport a batch to from a Combiner to a Separator through Process Flow. The problem I found is that with the logic I set, the transporter does not wait the separator to finish, accumulating batches in the separator. How can I avoid that? I would like the transporter to wait until the separator is empty. I know that it is much more easier to set the transport with 3D logic but I am interested in doing it with PF.

Thanks in advance.

question-separator.fsm

Ignacio

Software Version:

FlexSim 19.1.0

process flow separator

question-separator.fsm (56.3 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2020-03-12T15:24:54Z

Braydn T answered Mar 12, '20 JoseVM commented Mar 12, '20

@José Ignacio MN

Change the wait for event to OnContentChange, decrease to or through value, set value to 0, and check the fire if initial value meets rule.

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

JoseVM commented · Mar 12, 2020 at 04:15 PM

Check "fire if initial vale meets rule". That was the point, Thanks so much!

0 ·

question