hellow, i'm testing agv elevator but is not working
i change executer / task sequence token.ts and connect elevator to control point .
I don't know if I did something wrong. I would really appreciate it if you let me know. thanks
agv elevator is not working
FlexSim 19.0.0
Hi @Doris C, was tanner.p's answer helpful? If so, please click the red "Accept" button on their answer. Or if you still have questions, add a comment and we'll continue the conversation.
If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always unaccept and comment back to reopen your question.
You had a lot of things correct in your model, but your Process Flow was inhibiting the AGV Elevator from working. When you want an AGV to use the elevator, you should direct the AGV to the destination floor rather than the starting floor. In your model, you had some activities in the Process Flow at the point shown below that were directing the AGV to "EV2-U". If you do this, then the AGV Process Flow doesn't recognize that the AGV needs to travel to the third floor.
You should direct the AGV to the third floor immediately so that the Elevator recognizes it needs to be used (it will sense the difference in Z height between the control points). This way, the AGV will still travel to EV2-U on its way to the third floor, but since its actual destination is on the third floor, the Elevator will be called.
For additional help, you can review this User Manual section: Adding Elevators to AGV Networks
13 People are following this question.
