Problem / doubt in FlexSim AGVs tutorial - Task 4.3 - Step 6

Question

question

Manuel F. Silva asked Apr 25, '21 Manuel F. Silva answered Apr 26, '21

Problem / doubt in FlexSim AGVs tutorial - Task 4.3 - Step 6

After completing "STEP 6 Add Elevator Redirect and Entry Control Points" of the "Tutorial 4 - AGVs - TASK 4.3 - USING ELEVATORS WITH AGVS", I am not being able to make the elevator go up and down. The AGVs just cross the elevator to go to the different floors (and return from there) but without any movement of the elevator.

I attach the model on which I was working so that you can take a look at it: Automatic Guided Vehicles (AGVs) (1).fsm

Can anyone explain what I might be doing wrong. Thanks in advance.

Software Version:

FlexSim 21.0.4

flexsim 21.0.4

automatic-guided-vehicles-agvs-1.fsm (211.7 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2021-04-26T07:33:51Z

Manuel F. Silva answered Apr 26, '21

Dear @Seung Yong Seo, thank you very much for your assistance and explanation. In fact, after repositioning the control points, my model started working perfectly.

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 2 · 2021-04-26T00:29:54Z

David Seo answered Apr 26, '21

@Manuel F. Silva

You should drag and drop the control point on the path line EXACTLY to show the cross line in center of the control point like attached.

And then you can find the good result.

Your model is good.

2021-04-26-092548.jpg (97.6 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

question