question

Patrick Zweekhorst avatar image
0 Likes"
Patrick Zweekhorst asked Phil BoBo answered

FlexSim crashes when performing AGV travel

Hi,

I have created a small example model where FlexSim crashed directly after you press run. The crash seems to be caused by the AGV network and some path off set travel. The AGV gets a travel task to the control point directly behind the curve, with a path offset of -1. The control point is close to the start of the straight path, so I can imagine that the destination calculation is difficult/impossible. However crashing is not the solution I think. A clear exception message would be preferred.

(In this situation, when stopping before the control point stopping at the path the AGV is traveling on to the control point would also be a good solution).

Thank you for looking into this crash.

Patrick

Redirect_1.fsm

FlexSim 22.0.3
agvcrash
redirect-1.fsm (37.7 KiB)
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Phil BoBo avatar image
0 Likes"
Phil BoBo answered

Thanks for the bug report and sample model. I've added this to the dev list.

5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.