question

Guilherme G9 avatar image
0 Likes"
Guilherme G9 asked Jason Lightfoot commented

Invisible Conveyor causing corrupted model

I have read about this problem on another post but the suggested answer was to check the computer configurations. I have checked all the graphic and other requirements and believe that i match all of them. Also, i have been using FlexSim normally until yesterday when i encountered this problem, so why would it suddenly stop working.
Config.png

FlexSim 22.1.2
conveyorsystemcomputer configuration
config.png (29.7 KiB)
· 5
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jason Lightfoot avatar image Jason Lightfoot ♦♦ commented ·
Do other models draw correctly? An earlier version? Can you post the model? It may actually have been corrupted in which case the simplest solution is to go back to a previous version.
0 Likes 0 ·
Guilherme G9 avatar image Guilherme G9 Jason Lightfoot ♦♦ commented ·

PFC.fsm Yes other models draw correctly, i remember that i started the project on version 22.1.1, then i had the problem with the corrupted project and tried to update to version 22.1.2 but still didn't work.

0 Likes 0 ·
pfc.fsm (66.4 KiB)
Jason Lightfoot avatar image Jason Lightfoot ♦♦ Guilherme G9 commented ·
In that model you're referring to 'current' as the triggering object in a General Process Flow - which is incorrect, you can only detect entry on current in an Object Process Flow.
0 Likes 0 ·
Show more comments
Show more comments

1 Answer

Jason Lightfoot avatar image
0 Likes"
Jason Lightfoot answered Jason Lightfoot commented

I deleted the ConveyorSystem object in the model which then allows the render mode to be drawn for new conveyors.

pfc_jl.fsm


pfc-jl.fsm (92.3 KiB)
· 3
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Guilherme G9 avatar image Guilherme G9 commented ·
It worked, thanks!
0 Likes 0 ·
Guilherme G9 avatar image Guilherme G9 commented ·

@Jason Lightfoot my simulation won't run and it doesn't appear any error to check for.

PFC.fsm Here is the updated model.

0 Likes 0 ·
pfc.fsm (79.6 KiB)
Jason Lightfoot avatar image Jason Lightfoot ♦♦ Guilherme G9 commented ·
There's no error - you just haven't set it up to do anything. It creates two tokens that try to pull a base and top and the two sources create those objects but they have nowhere to go - they're not connected to the queue with an output.
0 Likes 0 ·