Display Stats from Sub Process Flow.fsm
I started a barebone process flow in which I call a sub flow:
In the sub flow, it just has a delay.
While I tried to pin the stats of the delay to the dash,
but nothing shows up.
I did set the sub flow as a global instance. Any help is appreciated.
The statistics collector that is created internally when pinning a stat to a dashboard uses the 'enumerate()' method to create a row for all instances of the chosen activity/activities on model reset. However, in the case of the subflow, the instances are created 'on demand', so it doesn't have an instance when the model is reset and thus no row is created.
You could either install the components of the dashboard table to get access to the statistics collector and change the event to listen to a token actually entering the activity (at which point the subflow instance will exits). The time until the first token enters will be missing from the 'average' calculation though.
Alternatively, you could simply place the subflow into a general process flow and connect the run subflow activity with the sampling tool.
14 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
