I have three 'prep' lines that all funnel into one machine. This machine has three lanes that all need be filled in order to run. I have the three lanes funneling into task individual processors, but I want the processors to wait until all three are full to run.
is there a way to do this?
Hi @Makenna A, was Jeanette F's answer helpful? If so, please click the "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.
If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always unaccept and comment back to reopen your question.
Hello @Makenna A,
I think the best way to do this would be to use a single combiner.
Each lane has different time intervals in the machine.
The machine cannot run unless all three lanes are 'stocked'.
The issue is the first run of the shift. Each lane needs to be fed to the machine before the machine can begin. Once the first cycle of all three lanes has begun, the machine will not stop, but the lanes need to continue to provide the machine with 3 continuous infeeds.
How do I simulate this machine so that it does not run unless all three lanes are stocked?
After the initial start-up of the machine, each lane exhausts its material at a different rate, but the hope is that the operator will have time to prep these lanes before exhausting its resources.
13 People are following this question.
© 1993- FlexSim Software Products, Inc. All Rights Reserved.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
