Hello
I want to start after completely filling the hangers in the A1 to A3 (Elevator 38 to Elevator 30) section. (The space between hangers should be maintained as previously set.)
I tried configuring and applying the Accumulation logic, but the hangers are gathered, but it does not resume.
Is there any good way?
At what time are hangers stuck and not resuming? When I run it the hangers all move.
I fixed a label error on DP44, and now non F1cars continue through the system - but you still have exceptions further in the process.
Thank you Janson,
However, when the simulation started, there was a space between the hangers,
After stopping the hanger at DP11 above Elevator30, wait until the hanger is full in the A1 ~ A3 section as mentioned above. If it is full, I want to make a hanger move
However, I want to implement the Accumulation logic using DP11, but it seems difficult at the moment.
You just need to stop the item without the delay and then resume the item when another DP28's entries have exceeded a number.
Hi @David.Y, was Jason Lightfoot's answer helpful? If so, please click the "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.
If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always unaccept and comment back to reopen your question.
I added the process to hold the hangers at a new DP until DP28 has had 39 hangers pass.
could you tell me about New DP? I don't find what you said NEW DP
16 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
