About the control point on the intersection.

Question

question

Sakamoto Ko asked Dec 6, '24 Jeanette F commented Dec 13, '24

About the control point on the intersection.

Hi.

I think we can see on which path the controlpoint is placed by looking at path node in the controlpoint's node.

However, when placed on a transfer point, there will be two of these nodes, which path is it actually supposed to be placed on?

Also, when a controlpoint is placed on a transfer point that has already been created, in what order are they stored in the path node?

By checking this, I would like to better manipulate the direction of the AGV when it is reset.

Thank you in advance.

Software Version:

FlexSim 24.0.2

agv controlpoint

1733491391558.png (41.0 KiB)

1733491536081.png (97.3 KiB)

1733491604497.png (23.0 KiB)

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jeanette F ♦♦ commented · Dec 13 at 12:26 AM

Hi @Sakamoto Ko, was Jordan Johnson's answer helpful? If so, please click the "Accept" button at the bottom of their answer. Or if you still have questions, add a comment and we'll continue the conversation.

If we haven't heard back from you within 3 business days we'll auto-accept an answer, but you can always comment back to reopen your question.

0 ·

Answer 1 · 2024-12-09T20:19:55Z

Jordan Johnson answered Dec 9, '24

If a control point is placed on a transfer, and an AGV is connected to that point, then the AGV will choose an arbitrary path to start on. There isn't a good way for you to control which path is the start path. If the AGV is required to start on a specific path, then you'll need to place a control point on the path, not on they intersection.

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

question