question

Mathilde DOUSSET avatar image
0 Likes"
Mathilde DOUSSET asked Adrian Haws edited

My system will stop when I puts run speed at max.

Hi!

I noticed that my system, when I put the position "run speed" at Max, after about 25000s , for example the conveyor 2 is empty while there are a gearbox in a separator.

Why is it?

Thank you!

I join you my system!100agv-autosave.fsm

FlexSim 16.2.0
time
100agv-autosave.fsm (13.1 MiB)
· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Matt Long avatar image Matt Long commented ·

@Mathilde DOUSSET I don't see Conveyor2 become empty until around 840000s, and even then the model is still running. Task Executers are still moving pallets around. Are you just trying to figure out why items aren't entering the conveyor anymore? From what I can see all of the combiners are in a blocked state. I'm not entirely sure how your logic is working to get items into the conveyor.

0 Likes 0 ·

1 Answer

Kaspar Chabot avatar image
0 Likes"
Kaspar Chabot answered Mathilde DOUSSET commented

Your simulation will stop if it gets stuck somewhere (No flowitems can flow anymore for some reason). This is independent of the run speed of your model. You have to find out why your model gets stuck at that exact time., solve it and then your model won't get stuck anymore.

· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Mathilde DOUSSET avatar image Mathilde DOUSSET commented ·

Yes, but I don't understand why my system will stop , there are any palets in the rack to block , there is one palet on each separator...

0 Likes 0 ·