question

Roan DJ2 avatar image
0 Likes"
Roan DJ2 asked Roan DJ2 commented

Transporter issue

Dear all,

I have a problem concerning the content of a transporter. I set the max. capacity of the transporter to 1, however the max. content after a simulation run is 2.

I hope someone is able to help me.

Kind regards,

Roan

laden-lossen.fsm

FlexSim 18.0.3
transporter
laden-lossen.fsm (166.9 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

·
Joerg Vogel avatar image
0 Likes"
Joerg Vogel answered Roan DJ2 commented

You are using ProcessFlow SubFlow Tasksequences. It is up to you to write a logic, that checks if there is capacity available. If you build the same model without SubFlow tasksequences the standard Flexsim functionality checks the capacity before a transport job is dispatched.

· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Roan DJ2 avatar image Roan DJ2 commented ·

Which subflow item can I use in my model to make sure the capacity of the Transporter is Always one?

0 Likes 0 ·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.