question

Brian W avatar image
0 Likes"
Brian W asked Isaac Litster answered

How to use the experimenter tool

initial-simulation-2.fsm

I want to test different queue sizes in my queue2 and how it effects the output in sink 1. I added an experimenter but I'm not sure how it is working. Can you help me out?

FlexSim 18.2.0
experimenter
initial-simulation-2.fsm (51.7 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Isaac Litster avatar image
0 Likes"
Isaac Litster answered

Hi @Brian W

There is a helpful experimenter tool example that I found. Here are some links.

Experimenter

Experimenter Example

If you are still stuck or need help after looking through these, let us know.

· 2
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Brian W avatar image Brian W commented ·

Nevermind - I just found where the "Direct Spatials Mode" is located direct-spatials.jpg

Thanks I'm good for now :)

1 Like 1 ·
direct-spatials.jpg (128.3 KiB)
Brian W avatar image Brian W commented ·

@Isaac Litster (or others) I ran into the following error when I was going through the experimenter tutorial - (https://answers.flexsim.com/articles/19670/experimenter-optimizer-example-15.html)

: "this is a calculated value that can't be sampled. Switch to Direct Spatials mode before sampling." Here is the picture flexsim-experimenter-error.jpg

Here is the flexsim I'm working on experimenter.fsm

How do I get past this?

Thanks - Brian

0 Likes 0 ·
experimenter.fsm (23.1 KiB)
flexsim-experimenter-error.jpg (140.4 KiB)